Coping (joinery)

A coped joint

A scribed joint (right end of sketch) is derived from an internal mitre cut (left end) by cutting along the inside face of the mitre cut at a right angle to the board, typically with acoping saw.

Scribinga pencil line to fit two pieces of wood together.

Copingorscribingis thewoodworkingtechnique of shaping the end of amouldingor frame component to neatly fit the contours of an abutting member. Joining tubular members inmetalworkingis also referred to as a cope, or sometimes a "fish mouth joint" orsaddle joint.

Most English-speaking countries outside the United States use the termsscribeandscribing.

Coping is commonly used in the fitting ofskirtingand other mouldings in a room. It allows for clean joints between intersecting members when walls are not square to each other. The other method of fitting these mouldings that is commonly used is themitre joint,but this technique relies upon knowing the precise angle between the walls for neat results. Coping is only ever used for internal corners. External corners are always mitred.

The main reason that scribed joints are used is that timber shrinks in width far more than it does in length. By using a scribed joint rather than an internalmitre joint,the effect of shrinkage is minimised. Also it is possible to arrange the scribed joints pointing away from the most common viewpoint (usually the doorway of a room) and so present the best appearance.

Coping is also commonly used incabinet-makingfor mouldings and frame components. The rails in theframe and panelconstruction are commonly cope cut to fit the profile of the stiles. The technique is also common in the construction of doors and windows.

Scribe joinery is also commonly used in the building of log homes. The shape of the log underneath is scribed into the bottom of a log to be placed on top. This provides a tight seal between the two adjacent logs. It is also commonly used in the building of boats since there is rarely a straight edge but frequently many curves.

Traditionally, coping would be performed using acoping saw.There are also mechanical means of producing coped joints, including matching rail and stile cutters for therouteras used in frame and panel construction.

See also

• Cope and stick

External links

• Tube Coping Calculator