Short-circuit test

The purpose of ashort-circuit testis to determine the series branch parameters of the equivalentcircuitof atransformer.

Method

The test is conducted on the high-voltage (HV) side of the transformer where the low-voltage (LV) side (or the secondary) isshort-circuited.Awattmeteris connected to the primary side. Anammeteris connectedin serieswith the primary winding. Avoltmeteris optional since the applied voltage is the same as the voltmeter reading. Now with the help ofa variac,the applied voltage is slowly increased until the ammeter gives a reading equal to the rated current of the HV side. After reaching the rated current of the HV side, all three instruments reading (Voltmeter, Ammeter, and wattmeter readings) are recorded. The ammeter reading gives the primary equivalent of full load current I_L.As the voltage applied for full load current in short circuit test on transformer is quite small compared to the rated primary voltage of the transformer, the iron losses in the transformer can be taken as negligible here.

Calculations

$W$ is the full-load copper loss

$V_{1}$ is the applied voltage

$I_{1}$ is the rated current

$R_{01}$ is the resistance as viewed from the primary

${Z_{01}}$ is the total impedance as viewed from the primary

${X_{01}}$ is the reactance as viewed from the primary

${W}={{I_{1}}^{2}}{R_{01}}$

${R_{01}}={\frac {W}{{I_{1}}^{2}}}$

${Z_{01}}={\frac {V_{1}}{I_{1}}}$

${X_{01}}={\sqrt {{Z_{01}}^{2}-{R_{01}}^{2}}}$

High-power tests

A short-circuit test for determination of transformer impedance and losses is carried out with relatively low power applied to the transformer, and with winding currents of the same magnitude as in operation. A different form of short-circuit testing is done to assess the mechanical strength of the transformer windings, and their ability to withstand the high forces produced if an energized transformer experiences a short-circuit fault. Currents during such events can be several times the normal rated current. The resultant forces can distort the windings or break internal connections. For large utility-scale power transformers, high-power test laboratories have facilities to apply the very high power levels representative of a fault on an interconnected grid system.

v t e Transformertopics
Topics	Balun Buchholz relay Bushing Center tap Circle diagram Condition monitoring of transformers Electrical insulation paper Growler High-leg delta Induction regulator Leakage inductance Magnet wire Metadyne Open-circuit test Polarity Pressure relief valve Quadrature booster Resolver Resonant inductive coupling Severity factor Short-circuit test Stacking factor Synchro Tap changer Toroidal inductors and transformers Transformer oil Dissolved gas analysis Transformer oil testing Transformer utilization factor Vector group
Types	Autotransformer Buck–boost transformer Distribution transformer Pad-mounted transformer Delta-wye transformer Energy efficient transformer Amorphous metal transformer Flyback transformer Grounding transformer Instrument transformer Current transformer Voltage transformer Isolation transformer Austin transformer Linear variable differential transformer Parametric transformer Planar transformer Rotary transformer Rotary variable differential transformer Scott-T transformer Solid-state transformer Trigger transformer Variable-frequency transformer Zigzag transformer
Coils	Hybrid coil Induction coil Oudin coil Polyphase coil Repeating coil Tesla coil Trembler coil
Manufacturers	ABB General Electric Mitsubishi Electric ProlecGE Schneider Electric Siemens TBEA

Method

Calculations

High-power tests

See also