Smurf attack

ASmurf attackis adistributed denial-of-service attackin which large numbers ofInternet Control Message Protocol(ICMP) packets with the intended victim'sspoofedsource IP are broadcast to acomputer networkusing an IPbroadcast address.Most devices on a network will, by default, respond to this by sending a reply to the source IP address. If the number of machines on the network that receive and respond to these packets is very large, the victim's computer will be flooded with traffic. This can slow down the victim's computer to the point where it becomes impossible to work on.

History

The original tool for creating a Smurf attack was written by Dan Moschuk (alias TFreak) in 1997.

In the late 1990s, many IP networks would participate in Smurf attacks if prompted (that is, they would respond to ICMP requests sent to broadcast addresses). The name comes from the idea of very small, but numerous attackers overwhelming a much larger opponent (seeSmurfs). Today, administrators can make a network immune to such abuse; therefore, very few networks remain vulnerable to Smurf attacks.

Method

ASmurf amplifieris a computer network that lends itself to being used in a Smurf attack. Smurf amplifiers act to worsen the severity of a Smurf attack because they are configured in such a way that they generate a large number ofICMPreplies to the victim at the spoofed source IP address.

In DDoS,amplificationis the degree of bandwidth enhancement that an original attack traffic undergoes (with the help of Smurf amplifiers) during its transmission towards the victim computer. An amplification factor of 100, for example, means that an attacker could manage to create 100 Mb/s of traffic using just 1 Mb/s of its own bandwidth.

Under the assumption no countermeasures are taken to dampen the effect of a Smurf attack, this is what happens in the target network withnactive hosts (that will respond to ICMP echo requests). The ICMP echo request packets have a spoofed source address (the Smurfs' target) and a destination address (the patsy; the apparent source of the attack). Both addresses can take two forms:unicastandbroadcast.

The dual unicast form is comparable with a regular ping: an ICMP echo request is sent to the patsy (a single host), which sends a single ICMP echo reply (a Smurf) back to the target (the single host in the source address). This type of attack has an amplification factor of 1, which means: just a single Smurf per ping.

When the target is a unicast address and the destination is the broadcast address of the target's network, then all hosts in the network will receive an echo request. In return they will each reply to the target, so the target is swamped withnSmurfs. Amplification factor =n.Ifnis small, a host may be hindered but not crippled. Ifnis large, a host may come to a halt.

If the target is the broadcast address and the patsy a unicast address, each host in the network will receive a single Smurf per ping, so an amplification factor of 1 per host, but a factor ofnfor the network. Generally, a network would be able to cope with this form of the attack, ifnis not too great.

When both the source and destination address in the original packet are set to the broadcast address of the target network, things start to get out of hand quickly. All hosts receive an echo request, but all replies to that are broadcast again to all hosts. Each host will receive an initial ping, broadcast the reply and get a reply from alln-1hosts. An amplification factor ofnfor a single host, but an amplification factor ofn²for the network.

ICMP echo requests are typically sent once a second. The reply should contain the contents of the request; a few bytes, normally. A single (double broadcast) ping to a network with 100 hosts causes the network to process10000packets. If the payload of the ping is increased to15000bytes (or 10 full packets inEthernet) then that ping will cause the network to have to process100000large packets per second. Send more packets per second, and any network would collapse under the load. This will render any host in the network unreachable for as long as the attack lasts.

Effect

A Smurf attack can overwhelm servers and networks. The bandwidth of the communication network can be exhausted resulting in the communication network becoming paralyzed.

Mitigation

The fix is two-fold:

1. Configure hosts and routers to ignore packets where the destination address is a broadcast address; and
2. Configure routers to not forward packets directed to broadcast addresses. Until 1999, standards required routers to forward such packets by default. Since then, the default standard was changed to not forward such packets.

It's also important for ISPs to implementingress filtering,which rejects the attacking packets on the basis of the forged source address.

Mitigation on a Cisco router

An example of configuring a router so it will not forward packets to broadcast addresses, for aCiscorouter, is:

Router(config-if)# no ip directed-broadcast

(This example does not protect a network from becoming thetargetof a Smurf attack; it merely prevents the network fromparticipatingin a Smurf attack.)

Fraggle attack

A Fraggle attack (named for the creatures in the puppet TV seriesFraggle Rock) is a variation of a Smurf attack where an attacker sends a large amount ofUDPtraffic to ports 7 (Echo) and 19 (CHARGEN). It works similarly to the Smurf attack in that many computers on the network will respond to this traffic by sending traffic back to the spoofed source IP of the victim, flooding it with traffic.

Fraggle.c,thesource codeof the attack, was also released by TFreak.

See also

• Denial-of-service attack
• Ping flood
• Smurf Amplifier Registry

External links

• The Latest In Denial Of Service Attacks: "Smurfing",Craig A. Huegen, 1997.