Plug and Play RTTY and LoRa High Altitude Balloon Tracker for Arduino and SX127x (or Hope RFM9x).
TBTracker is a sketch for a tracker for high altitude weather balloons. It will send telemetry data in RTTY and LoRa format. It is designed to send telemetry data in the correct format forhttps://tracker.habhub.org/
It can send data in RTTY or LoRa format on different frequencies and with different callsigns.
Currently it supports:
- Time
- Longitude
- Latitude
- Altitude
- Number of satellites visible
- Internal temperature
- Internal voltage
- External voltage
The code as is, is for the SX1278 module. If you have a SX1276, then change line 5 in radio.ino. See the comments in that file.
You will need two extra Arduino libraries to be able to compile this sketch.:
https://github /jgromes/RadioLib(Radiolib, use version 5.5.0 or lower to overcome out of memory errors if you are using an Arduino mini)
https://github /mikalhart/TinyGPSPlus(tinyGPS++)
To run this, you need a TTGO T-Deer board or:
- 1 x Arduino Mini - 3.3v (or compatible Arduino board)
- 1 x SX1278 LoRa chip (or compatible LoRa chip. Basically it will work with all sx127x series chips)
- 1 x ATGM336H or any UBlox or compatible GPS device like a NEO6 or NEO8. I recommend the ATGM336H GPS module.
Note that currently setting different flightmodes in uBlox GPS modules is not supported. This could cause GPS failures above 18km when using uBlox GPS modules. I recommend using the ATGM336H GPS modules.
Connect the T-Deer as an Arduino Mini to the Arduino IDE. Many parameters are user adjustable in settings.h
The Arduino Pro mini has a rather small memory capacity. If you run into memory issues, consider disabling RTTY or LORA in the settings.h file. Also disabling DEVMODE in settings.h will free up a lot of memory at the cost of no serial output.
Have fun,
Roel.
V0.1.0:
- 2023-01-20 - Added support for LoRa HAB mode 0
- 2023-01-20 - Added support for LoRa HAB mode 1 (Telemetry only)
- 2023-01-20 - Added support for LoRa HAB mode 3
- 2023-01-20 - Added support for LoRa HAB mode 5
- 2023-01-20 - Added support for Low Data Rate Optimization